I will post my section for reference, but my bltouch is in an unorthodox place, so I would recommend reading through the documentation and choosing your own probe points after some testing on your machine. DUAL CL 101 FULL RANGE at - 909705610 Back to homepage. Shape Console with any shape - in general Dimensions (WHD) 360 x 660 x 240 mm / 14.2 x 26 x 9. Availability: In Stock Product Code: CL-FC101. CL100 (1) Technical Specifications Wave bands - without Power type and voltage No Power needed Loudspeaker 4 Loudspeakers Power out 40 W (50 W max.) Material Wooden case from Model: CL100 - Dual, Gebr. step_pin: PD11 dir_pin: !PD10 enable_pin: !PD13 microsteps: 16 rotation_distance: 4įor the z_tilt section look here. UL Dual Certified to current NFPA 1977 & 1975 Specifications Certified to Meet the Requirements of. My z stepper setup for the SKR 1.4 turbo looks like this: To find the correct pin values look for documentation for your specific model of board. Literally would take plugging one connector in elsewhere and putting 5 lines in the firmware to make leveling 100x easier /rant Aside from plugging one of the z steppers into the extruder1 driver, you need to add a stepper_z1 section to your config after your stepper_z, and a z_tilt.įor the stipper_z1 copy/paste everything from here: except the endstop_pin (presuming you have that defined in the stepper_z section), uncomment the variables and define them. It is incredibly frustrating that they ship a printer this large with all the hardware needed to run independent z axes, but link them instead.
0 Comments
Leave a Reply. |